Connect Antenna Cable; Power Connection; Initial Installation; Select Source - AEG CTV 1902 LED/DVB-T Instruction Manual

4.3 Connect Antenna Cable

The TV set festures a tuner to receive TV signals via antenna/cable and DVB-T signals.
CAUTION:
• Connect the antenna cable before connecting to mains power supply.
• DVB-T reception: The device is intended for reception via passive DVB-T antenna.
• Connect the DVB-T antenna to RF input.
• In the source menu (press SOURCE button) select DTV.
Other Antenna Connections
For optimum trouble-free picture quality use a dual shielded 75 ohm antenna cable.
1. Connect a 75 ohm antenna cable to the antenna wall outlet.
2. Connect the other end to antenna input RF at the rear of the device.
3. In the source menu (press SOURCE button) select ATV.
NOTE:
To be able to watch TV you first have to search for channels ( see "4.5 Initial Installation" on page 57).

4.4 Power Connection

The television device is set up for alternating current 100-240 V, 50/60 Hz.
• Plug the power plug into a properly installed outlet.
CAUTION:
Connect all devices before connecting the TV set to mains power supply. The wall outlet must be freely accessible at all
times.

4.5 Initial Installation

When turning the TV set on for the first time a window is displayed to
select the menu language and to start Channel Search.
1. Turn on the device with the power switch, located at the right
bottom of the device. When the indicator light turns red, press the
POWER button on the remote control. The "Select OSD Lan-
guage" window is displayed.
2. Press OK to confirm German as OSD language or press the arrow
buttons / / / on the remote control and OK to select your
language.
3. Press the arrow buttons / / / to select the country of your location.
4. Press OK to start Channel search. This process will take a few minutes. Progress is displayed on screen.

4.6 Select Source

1. In on mode press the SOURCE button. The source menu (connected devices) is dis-
played.
2. Press the arrow buttons / on the remote control or CH +/- on the device to select
the desired source.
3. Press OK or VOL +/- on the device to confirm.
NOTE:
Press the EXIT button to exit the menu without changes.
ENGLISH
57