Connect Antenna Cable; Power Connection; Initial Installation - AEG CTV 3204 LED Instruction Manual

English
32
• Mount the base plate onto the stand.
• For protection of the device, place a blanket onto a sturdy table that can support the weight of the television.
• Carefully place the screen of the television onto the blanket.
• Attach the stand with the Phillips screw.
• Remove the protective film from remote control and TV set, if attached.
• Place the TV set on a stable, level surface. Ensure that the surface can carry the TV's weight.
• Protect the device from extreme heat and humidity.
• Ensure sufficient ventilation on all sides. When placed in a wall unit leave at least 20 cm on top and 10 cm distance at
the sides for ventilation.
NOTE: Wall mounting
• You can alternatively mount the device with the help of a suitable VESA standard wall bracket (available from deal-
ers) to a suitable wall.
- Gap between holes in millimeters: 200 x 100.
- Thread: M4. The pitch length of the screws may not exceed 10 mm.
• The stand is not fitted when mounting to a wall.
• Maintain a clearance of at least 8 cm for ventilation around the device.
• Check the reach of the cable! When mounting the device, make sure that an easily accessible outlet is available
within reach of the power cable.

4.3 Connect Antenna Cable

The TV set festures a tuner to receive TV signals via antenna/cable and DVB-T signals.
CAUTION:
• Connect the antenna cable before connecting to mains power supply.
• DVB-T reception: The device is intended for reception via passive DVB-T antenna.
• Connect the DVB-T antenna to ANT input.
• In the source menu (press SOURCE button) select DTV.
Other Antenna Connections
For optimum trouble-free picture quality use a dual shielded 75 ohm antenna cable.
1. Connect a 75 ohm antenna cable to the antenna wall outlet.
2. Connect the other end to antenna input ANT at the rear of the device.
3. In the source menu (press SOURCE button) select ATV.
NOTE:
To be able to watch TV you first have to search for channels ( see "4.5 Initial Installation" on page 32).

4.4 Power Connection

The television device is set up for alternating current 100-240 V, 50/60 Hz.
• Plug the power plug into a properly installed outlet.
CAUTION:
Connect all devices before connecting the TV set to mains power supply. The wall outlet must be freely accessible at all
times.

4.5 Initial Installation

When turning the TV set on for the first time a window is displayed to
select the menu language and to start Channel Search.
1. Turn on the device with the power switch, located at the right
bottom of the device. When the indicator light turns red, press the
POWER button on the remote control. The "Please select an
OSD Language" window is displayed.
2. Press the arrow buttons / / / on the remote control and OK
to select your language.