Kodak EASYSHARE V803 Manual page 105

KODAK EASYSHARE V803/V1003 Zoom Digital Camera Manual
http://www.kodak.com/global/en/service/publications/urg0...ml?chapsec=urg00665c6s0&pq-path=10/3905/7168/10510/10540 (3 of 4)19/01/2007 16:36:56
Slide Show does not run on an
external video device
Computer does not communicate
with the camera
Picture quality problems
Status Solution
Picture is not
clear
Picture is too dark
Adjust the camera Video Out setting to NTSC or PAL
( ).
Make sure the external device settings are correct.
(See the device's user's guide).
Make sure the battery is charged and installed
correctly (see
Turn on the camera.
Make sure the USB cable model U-8 is connected to
the camera and the computer (see
cable). (If using an EasyShare dock, check all cable
connections. Make sure the camera is seated on the
dock.)
Make sure EasyShare software is installed (see
Installing the
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter button
completely down to take the picture.
Clean the lens (see Care and
Make sure the camera is not in Macro mode if you are more than 27.6 in.
(70 cm) from your subject.
Place the camera on a flat, steady surface or use a tripod (especially in
high-zoom settings or in low light).
Reposition the camera for more available light.
Use Fill flash (see Using the
behind the subject.
Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on see
specifications.)
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter button
completely down to take the picture.
Loading the KLIC-7003 battery).
Using the USB
software).
maintenance).
flash) or change your position so light is not
Camera