Table of Contents
Advertisement
CARBON MONOXIDE POISONING HAZARD
Special Warning for Installa on of Furnace or Air Handling Units in
Enclosed Areas such as Garages, U lity Rooms or Parking Areas
Carbon monoxide producing devices (such as an automobile, space
heater, gas water heater, etc.) should not be operated in enclosed areas
such as unven lated garages, u lity rooms or parking areas because of
the danger of carbon monoxide (CO) poisoning resul ng from the exhaust
emissions. If a furnace or air handler is installed in an enclosed area such
as a garage, u lity room or parking area and a carbon monoxide producing
device is operated therein, there must be adequate, direct outside
ven la on.
This ven la on is necessary to avoid the danger of CO poisoning which
can occur if a carbon monoxide producing device con nues to operate in
the enclosed area. Carbon monoxide emissions can be (re)circulated
throughout the structure if the furnace or air handler is opera ng in any
mode.
CO can cause serious illness including permanent brain
damage or death.
RIESGO DE INTOXICACIÓN POR MONÓXIDO DE CARBONO
A dvertencia especial para la instalación de calentadores ó manejadoras
de aire en áreas cerradas como estacionamientos ó cuartos de servicio.
Los equipos ó aparatos que producen monóxido
(tal como automóvil, calentador de gas, calentador de
gas, etc) no deben ser operados en áreas cerradas debido al riesgo
de envenenamiento por monóxido de
emisiones de gases de combus ón.
dichas áreas, debe exis r una adecuada ven lación directa al exterior.
Esta ven lación es necesaria para evitar el peligro de envenenamiento
por CO, que puede ocurrir si un
de carbono sigue operando en el lugar cerrado.
Las emisiones de monóxido de carbono pueden circular a través
del aparato cuando se opera en cualquier modo.
El monóxido de carbono puede causar enfermedades severas
como daño cerebral permanente ó muerte.
RISQUE D'EMPOISONNEMENT AUMONOXYDE DE CARBONE
Aver ssement special au sujet de l'installa on d'appareils de chauffage
ou de traitement d'air dans des endroits clos, tets les garages, les
locaux d'entre en et les sta onnements.
Evitez de me re en marche les appareils produisant du monoxyde
de carbone (tels que les automobile, les appareils de chauffage
autonome,etc.) dans des endroits non ven lés tels que les
d'empoisonnement au monoxyde de carbone. Si vous devez faire
fonc onner ces appareils dans un endroit clos, assures-vous
qu'il y ait une ven la on directe provenant de l'exterier.
Ce e ven la on est nécessaire pour éviter le danger d'intoxica on
au CO pouvant survenir si un appareil produisant du monoxyde
de carbone con nue de fonc onner au sein de la zone confinée.
Les émissions de monoxyde de carbone peuvent etre recircules dans les
endroits clos, si l'appareil de chauffage ou de traitement d'air sont
en marche.
Le monoxyde de
carbone peut causer des maladies graves telles que
des
dommages permanents au cerveau et meme la mort.
General Information
To prevent property damage, personal injury or death, due to fire,
explosions, smoke, soot, condensation, electric shock or carbon
monoxide, this unit must be properly installed repaired, operated, and
maintained.
B10259-216
de carbono
agua por medio de
carbono (CO) que resulta de las
Si el equipo ó aparato se opera en
disposi vo que produce
monóxido
B10259-216
B10259-216
WARNING
This unit is approved for outdoor installation ONLY. Rated
performance is achieved after 20 hours of operation. Rated
performance is delivered at the specified airflow. See outdoor unit
specification sheet for split system models or product specification
sheet for packaged and light commercial models. Specification
sheets can be found at www.daikincomfort.com for Daikin® brand
products. Within the website, please select the residential or
commercial products menu and then select the submenu for the
type of product to be installed, such as air conditioners or heat
pumps, to access a list of product pages that each contain links to
that model's specification sheet.
To assure that your unit operates safely and efficiently, it must
be installed, operated, and maintained in accordance with these
installation and operating instructions, all local building codes
and ordinances, or in their absence, with the latest edition of the
National Fuel Gas Code NFPA 54/ANSI Z223.1 and National
Standard of Canada CAN/CSA B149 Installation Codes.
The heating and cooling capacities of the unit should be greater
than or equal to the design heating and cooling loads of the area
to be conditioned. The loads should be calculated by an approved
method or in accordance with A.S.H.R.A.E. Guide or Manual J -
Load Calculations published by the Air Conditioning Contractors
of America.
Obtain from:
American National Standards Institute
25 West 43rd Street, 4th Floor
New York, NY 10036
Transportation Damage
Check the carton upon arrival for external damage. If damage is
found, a request for inspection by carrier agent should be made in
writing immediately.
Carefully inspect the unit for damage including damage to the
cabinetry. Any bolts or screws which may have loosened in transit
must be re-tightened. In the event of damage, the receiver should:
1. Make notation on delivery receipt of any visible damage to
shipment or container.
2. Notify carrier promptly and request an inspection.
3. In case of concealed damage, carrier should be notified as
soon as possible-preferably within 5 days.
4. File the claim with the following supporting documents:
a. Original Bill of Lading, certified copy, or indemnity bond.
b. Original paid freight bill or indemnity in lieu thereof.
c. Original invoice or certified copy thereof, showing trade and
other discounts or reductions.
d. Copy of the inspection report issued by carrier
representative at the time damage is reported to the carrier.
The carrier is responsible for making prompt inspection of
damage and for a thorough investigation of each claim.
The distributor or manufacturer will not accept claims from
dealers for transportation damage.
NOTE: When inspecting the unit for transportation damage,
remove all packaging materials. Recycle or dispose of the
packaging material according to local codes.
5
Advertisement
Table of Contents
