Optimus H-8214 Instruction Manual And Owner's Manual page 3

OPERATING INSTRUCTIONS
NOTE: There is a MAIN POWER SWITCH at the BACK of the heater.
1. Start and select working mode
2. Setting Desired Temperature
Turn the heater on by pressing the ON/OFF button
on the control panel or by pressing the Power
button on the supplied remote control.
Once power is off, heating element will stop
working at first. Fan will prolong working for 1
minutes to emit plenty of heat inside and to cool
down all the heating elements.
Select a heat Mode
Press the MODE button to toggle between the
three heat
modes.
High Mode uses 1500W; Low Mode uses 750W.
ECO mode is an Economic Energy Saving
Function. When ECO mode is chosen, the heater
will operate from less to more heating power
(watts) in an attempt to maintain a constant warm
68℉(20℃).
NOTE: When ECO Mode is on, the heater will not
cycle on and off. Heater will continue working to
maintain the desired temperature.
Adjust the desired temperature by pressing the
Up/Down arrows on the control panel or remote
control.
Desired temperature options vary from 59℉ to 86
℉,or from 15℃ to 30℃. Once you have chosen
the desired temperature, the heater will remain on
until the room temperature increases to the
temperature on the digital display. The heater will
cycle on and off to maintain the desired room
temperature.
Press ℃/℉ button to change the
display temperature between
Fahrenheit and Celsius.
The Fahrenheit indicator LED will light , when the
temperature is displayed in Fahrenheit.
The Celsius LED will light, when the temperature is
displayed in Celsius.
3. Setting the POWER OFF TIMER Function
Note: The Power-Off-Timer Function will allow for the heater to power OFF after a certain set time, and
can only be set while the heater's display is in the "On" position.
4. Setting the POWER-ON-TIMER Function
Note: The Power-ON-Timer Function will allow for the heater to power ON after a certain set time, and
can only be set while the heater's display is in the "Off" position.
Turn the heater to the "On" position .Press the
Timer button on the heater's control panel or the
remote.
The digital display changes from the "temperature"
to the "hours" option for the timer. Continue to
press the timer button to change the number of
hours you would like the heater to run before
powering itself off .The hour options for the timer
are from 0 to 12 hrs. (in 1 hr increments).
The selected hour increments will flash for a few
seconds, then revert back to the set desired
temperature .The Timer indicator light will remain lit
as long as the Timer is set. The heater will power
OFF when the internal heater clock counts down
the hour increments you set.
Turn the heater to the "OFF" position .Press the
Timer button on the heater's control panel or the
remote.
The digital display shows the "hours" option for the
timer. Continue to press the timer button to change
the number of hours you would like the heater's
internal clock to count down before powering itself
on .The hour options for the timer are from 0 to 12
hrs. (in 1 hr increments).
The Timer indicator light will remain lit as long as
the Timer is set. The heater will power itself ON
when the internal heater clock counts down the
hour increments you set.