Settings Mode; Recording Modes; File Transfer To A Computer; Standby Mode - Kayoba 011187 Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

USE
INSERTION AND REMOVAL OF
MEMORY CARD
1.
Check that the trail camera is switched off
before inserting or removing the memory
card.
2.
Insert the memory card the right way
round in the memory card slot. Risk
of data corruption or data loss if the
memory card is put in the wrong way
round.
3.
To remove the memory card, press it down
with the tip of your finger until it clicks.
Lift off the finger. The memory card then
springs out of the camera.

File transfer to a computer

1.
Start the camera (put the switch in the
ON position) and connect to a computer
(PC or Mac) with the supplied micro USB
cable. A connection image is shown on
the camera display.
2.
The video and photo files on the memory
card are now accessible from the computer.
NOTE:
File transfer can also be carried out by
removing the memory card from the camera
and putting it in a card reader.
HOW TO USE

Standby mode

Switch on the power switch (ON). The camera
goes in standby mode and automatically takes
stills/video sequences according to the settings
for the length of intervals and video recordings.

Switching off

Switch off the switch (OFF).

Settings mode

Move the switch to settings mode (SET).
Stills can be taken in this mode, video
sequences can be played manually, and stored
photo files and video files can be shown.

Recording modes

Video/photo
1.
Press the up or down button in SET mode
to switch between modes.
2.
Move the switch to the ON position
when the required recording mode has
been selected. A 15 seconds countdown
indicates when the camera starts to
record.
Video recording
1.
Press the up button to use this mode for
video recording.
2.
In settings mode (SET), press the right-
hand button to start video recording.
3.
Press the right-hand button once again to
stop video recording.
Taking stills
1.
Press the down button to use this mode
to take stills.
2.
Press the right-hand button to take a photo.
Display mode
Use this mode to show stored photo and video
files.
1.
Press the OK button to show stored video
files and use the up or down button to
browse through the stored photo and
video files.
EN
17

Advertisement

Table of Contents
loading

Table of Contents