G-Fittings 45.100x.090.12 Quick Start Manual page 7

Find Hinge with number adjuster
1. Hex wrench 5 mm: Press the adjuster down & turn all the power
adjusters from higher numbers to N. (from 7-6-5-4-...-0-N)
Find Hinge with Hold-open (O)
2. Hex wrench 3 mm: loosen the side set screw a
little bit
Hex wrench 5 mm: turn the Hold-open part from – to + to the
end
Hex wrench 3 mm: tighten the side set screw (pink sticker) again
Find Hinge with hydraulic buffer (H)
3. Hex wrench 3 mm: turn the Hydraulic part from – to + to the
end.
4. Hex wrench 3 mm: loosen the side set screw (pink sticker) a
little bit
Hex wrench 5 mm: turn the Hydraulic part from + to – to the
end.
Hex wrench 3 mm: tighten the side set screw (pink sticker) again
Reset the hinge to out of box settings
(S)