Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Hydrofarm Autopilot APCEM
Summary of Contents for Hydrofarm Autopilot APCEM
- Page 1 INSTRUCTIONS DESKTOP CO MONITOR APCEM...
- Page 2 Recovers the factory settings MaxMin minimum CO reading before being RcFS and purges customized cleared or after Power On settings The beep alarm can be set on/off For setting the user- MUTE ALARM 1 under Mute Mode adjustable first alarm level www.Hydrofarm.com...
- Page 3 INSTRUCTIONS For setting the user-adjustable ALARM 2 second alarm level SAFETY INSTRUCTIONS WARNING: Your safety is very important to us. To ensure that you use the product correctly and safely, please read the warnings and this entire instruction booklet before using the product. They contain important safety information which should be observed at all times.
- Page 4 Alarm level is ≥1,000 ppm, the interval is ±100ppm, and when the CO Alarm level is ˂1,000 ppm, the interval is ±50 ppm. After setting a new alarm level parameter, the green LED will light when CO concentration is below the Alarm 1 level. www.Hydrofarm.com...
- Page 5 INSTRUCTIONS SETTING THE ALARM 2 LEVEL 1. Press Mode. The ALARM 2 icon will flash. 2. Press Enter. Use Up/Down to set the parameter. The default ALARM 2 is 1200 ppm. 3. Press Enter again to save the data. NOTE: As with Alarm 2, when CO Alarm level is ≥1,000 ppm, the interval is ±100ppm, when the CO Alarm level is ˂1,000 ppm, the interval is ±50 ppm.
- Page 6 NOTE: With the Built-in MAX MIN mode, the APCEM can provide the maximum and minimum CO readings since the device has last been turned on. If users press Up/Down to clear the MAX and MIN CO reading record, the APCEM will provide the new MAX and MIN CO reading from that time. www.Hydrofarm.com...
- Page 7 TROUBLESHOOTING & SPECS USING THE RCFS MODE: 1. Press Mode. The RcFS icon will flash. 2. Press Enter. The icon “no” will show on the LCD. Press Up/Down to select no/yes. 3. After selecting, press Enter to save the setting. NOTE: If through an error incorrect data is set or the APCEM is calibrated incorrectly, use RcFS (Recover the Factory Setting) to reset to the default factory settings.
- Page 8 Misuse, abuse, or failure to follow instructions is not covered under this warranty. Hydrofarm will, at our discretion, repair or replace the APCEM covered under this warranty if it is returned to the original place of purchase. To request warranty service, please return the APCEM, with original sales receipt and original packaging, to your place of purchase.
Need help?
Do you have a question about the Autopilot APCEM and is the answer not in the manual?
Questions and answers