Maintenance - Scandomestic EMF 990 User Manual

MAINTENANCE

The cleaning of the carbon grease filter mesh (PS: when you
clean the hood, please make sure the power is cut off)
• The way of take off the hood's grease filter: be careful to
take off the grease filter screws in the anticlockwise by
hand, drag down and pick the grease filter out. See pic.17.
Please strictly follow the guidelines below.
1 Put the mesh into 40-50°C clean water, pour on detergent,
and soak for 2-3 mins. Wear gloves and clean with a soft
brush. Please do not apply too much pressure, as the mesh
is delicate and will damage easy.
2 If instructed to do so, it can be put into a dishwasher, set the
temperature at around 60 degrees.
• Please not use abrasive detergent, it will damage the hood.
• Install the carbon filter into cooker hood, the specific install
way can see pic.18.
The way of changing lamp:
Make sure that the hood is shut off before changing.
• The way of take off the hood's grease filter: be careful to
take off the grease filter screws in the anticlockwise by
hand, drag down and pick the grease filter out.
• Use screw driver to take off the shelter board 6 pcs of ST3 x
6 mm screws and pick out the lamp's shelter board.
• Take off the lamp and change it.
10