Advertisement
Documentation Center
Configuring RAK4600
You can configure your RAK4600 Evaluation Board by sending AT Commands either through BLE or through
micro USB.
NOTE:
For the full list of AT Commands available for configuring your RAK4600, please refer to the
Manual.
Through Micro USB
1. As mentioned in
Checking Device
should connect the RAK4600 to Windows PC as shown in the image below:
2. Try to send a simple AT command to RAK4600 to get the current firmware's version by sending the command
below using the RAK Serial Port Tool. Similarly, you can send other AT commands of RAK4600 in the same
way.
at+version
Logs, if you want to use RAK4600 Evaluation Board through UART, you
Figure 7: RAK4600 Evaluation Board to Windows PC Connection
AT Command
sh
Advertisement
