ECOVACS ROBOTICS WINBOT X Instruction Manual page 14

2. Operating WINBOT
Start Cleaning
6
If there's too much dirt on the glass, use the finishing cloth to clean an
area on the glass where Safety Pod is to be attached.
14
EN
Make sure the bottom power switch is switched to "I". ("I" = ON,
"O" =OFF) Press to start the fan. After Safety Pod is attached
successfully, WINBOT starts cleaning automatically.
* When cleaning a frameless glass, keep Safety Pod more than
10cm/3.94" away from the edge.
* After WINBOT is started, keep the fan away from hair or any debris.