Beper BP.651H Use Instructions page 10

4 in 1 Hand Blender Use instructions
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without expe-
rience or technical ability to use the appliance if they are not properly
watched over. Close supervision is necessary when any appliance
used by or near children.
Make sure that children do not play with this appliance.
If you decide not to use the appliance any longer, make it unservice-
able by simply cutting the supply cable after disconnecting the plug
from the socket.
ALSO MAKE ANY DANGEROUS PARTS UNSERVICE-
ABLE, ESPECIALLY FOR CHILDREN WHO COULD
PLAY WITH THE APPLIANCE.
WARNINGS FOR USE
Before connecting the appliance to the socket, make sure that the mains voltage is the same as that shown
on the technical data label and that the system is compatible with the blender power. Before using the blender,
check its integrity and the one of power cord.
Be careful that power cord does not touch sharp edges or hot surfaces, or been smashed. For domestic use.
Do not leave the blender unnecessarily plugged in. Turn it off and disconnect the plug from the mains power
supply when the blender is not in use.
Do not pull the power cord off the blender.
Keep an adequate distance from walls, objects, and so on.
Pay particular attention to the sharp blade, especially when the plug is plugged into the socket. Remove the
blade from the chopping container before removing the food.
Always wait for the blade to be completely firm, before removing the cover of the chopping container.
Ingredients must always be placed in the processing container when the blender is off.
Before removing the ingredients that are attached to the blade during the machining phase, unplug the plug from
the socket.
DO NOT KEEP THE BLENDER IN OPERATION FOR MORE THAN 30 SECONDS TO AVOID OVERHEATING,
AND WAIT AT LEAST 5 MINUTES BEFORE USING IT LATER.
Never leave the immersion blender unattended and unattended when it is in operation.
Do not use the blender when empty.
Use the immersion blender on a horizontal, dry and safe surface.
Remove the accessories before washing them.
Do not immerse the engine body and power cord in water or other liquids. If accidentally penetrate water inside
the blender, dry the unit and have it checked by service center.
Do not use the blender with wet hands and / or bare feet.
Do not touch moving parts. Keep your hands, hair, clothing or other kitchen utensils away from the whisk and
blades when moving, to avoid the risk of personal injury and / or damage to the blender itself.
Before assembling, disassembling or clean the blender disconnect the plug from the socket.
10