Important Notes - T+A POWER BAR 2+3 Operating Instructions Manual

Important notes

Care of the unit
Enclosure openings

Overload
Service and damage
The operation instructions, the connection guidance and the
safety notes are for your own good - please read them carefully
and observe them at all times. The operating instructions are an
integral part of this device. If you ever transfer the product to a
new owner please be sure to pass them on to the purchaser to
guard against incorrect operation and possible hazards.
If the unit gets very cold (e. g. when being transported),
condensation may form inside it. Please do not switch it on until it
has had plenty of time to warm up to room temperature, so that
any condensation evaporates completely.
Disconnect the mains plug at the wall socket before cleaning the
case.
The surfaces of the case should be wiped clean with a soft, dry
cloth only.
Never use solvent-based or abrasive cleaners!
Before switching the unit on again, check that all cables are
plugged in correctly
Liquid or particles must never be allowed to get inside the unit
through the ventilation slots. Mains voltage is present inside the
unit, and any electric shock could cause serious injury or death.
Never exert undue force on mains connectors.
Protect the unit from drips and splashes of water; never place
flower vases or fluid containers on the unit.
Do not place naked flame sources, such as candle lights on the
device.
The device is designed to operate in a temperate climate and
altitudes up to 2000 m above sea level. The range of permissible
operating temperatures is +10 ... +30°C.
Make sure that the connected devices do not exceed the
maximum total load capacity (see Technical data) of the POWER
BAR.
Connecting loads which together exceed the total load capacity
of the POWER BAR may result in fire and destruction of the
POWER BAR.

The case should only be opened by a qualified specialist
technician. Repairs and fuse replacements should be entrusted
to an authorised  specialist workshop. With the exception of
the connections and measures described in these instructions,
no work of any kind may be carried out on the device by
unqualified persons.
If the unit is damaged, or if you suspect that it is not functioning
correctly, immediately disconnect the mains plug at the wall
socket, and ask an authorised  specialist workshop to check
it.
12