Features, Rear Panel - Bell ZX1024M Manual

Features, Rear Panel

CH.1..3
Combo Socket to connect either a
balanced line XLR (m) or a 6.3mm jack
plug for line level inputs (-20dB)
CH.4
XLR socket to connect a balanced line
XLR (m) plug. Extra stereo line input
via separate 6,3mm left and right jack
sockets.
L/mono will connect a mono source
using one jack plug only.
AUX 1
RCA / Cinch Sockets (3 pairs) to connect
stereo-line sources. (CD/MP3 players
etc.) Select the input source by the
AUX1 rotary switch.
AUX 2
RCA / Cinch Sockets (2 pairs) to connect
stereo-line sources. (CD/MP3 multi me-
dia players etc.) Select the input source
by the AUX2 rotary switch.
Extra USB input socket (parallel to USB
front side input)
INPUT
EXT
CHANNELS
OUTPUT
®
Pin connection (XLR), balanced:
1=Ground, 2=Hot, 3=Cold
Should only an unbalanced signal source
be available, a wire bridge must be
inserted between pins 1 and 3 of the
signal cable.
Pin connection (Jack socket) ,
Housing: cold (-), Tip: hot (+)
The connection of an unbalanced signal
via a 2-pin jack plug is also possible.
MP3 Remote control
Jack socket to connect an external mo-
mentary switch (m/o) to start the built-
in MP3 player.
Auto Mute Threshold
Input channels Mic1..4 as well as the
MP3 player channel come with an extra
auto mute function.When activated, the
level of any signal on channel AUX1 and
Aux2 will automatically be reduced.
The sensiitivity (threshold level) is set by
the ‚Threshold' rotary control.
GROUP & MASTER
OUTPUT CHANNELS
technische Änderungen vorbehalten - specifications may change without notice
EXT Out
Selected output signals may be send
(pre-master) via the EXT Out sockets
Left / Right (6,3mm jack / RCA)
Outputs G1,2,3,4,5
When a push switch for these outputs
has been set at any input channel,
Signals are routed to the group outputs
Group 1...5 and hence to the balanced
line XLR output sockets. These outputs
will normally drive connected power am-
plifiers or audio management systems.
Outputs Left / Right
When a push switch for these outputs
has been set at any input channel, Si-
gnals are routed to the master outputs
Left / Right and hence to the balanced
line XLR output sockets. These outputs
will normally drive connected power am-
plifiers or audio management systems.
Insert
Jack sockets (switch type) to insert
external devices, such as eqalizers, Con-
trollers, effect units etc.
Takes 6,3mm stereo-jack plug.
Tip=Send, Ring=Return, Body=(-)
Mains
Use only the supplied mains cable.
90 - 230VAC. / earthed.
The mains fuse is located in the lower
part of the mains socket.
Fuse: 230V/1A/Slow