Jäger ADwin Manual For The Installation page 6

Information about this manual
2
Before installation of the ADwin CDROM
An important note:
Please, pay absolutely attention to the order of the installation steps.
This refers especially to the initialization of the hardware.
1. Installation or update of the ADwin CDROM:
2. Installation of the interface drivers (USB,
Ethernet etc.),
Initialization of the hardware,
Functions check.
Pay also attention to the notes for initializa-
tion in your hardware manual.
3. First steps in ADbasic.
4. Introduction to ADbasic programming
For installation step 2 choose the suitable chapter for your ADwin system in the
table:
ADwin system
– Systems with ADlink PC ISA board
– ADwin boards
– ADwin-light boards (not ADwin-light-16)
– ADlink PCI adapter board
– ADpcmcia linkadapter board
– ADwin-light-16 (PCI, EURO, cPCI, EXT)
with USB interface
– ADwin-Gold
• ADwin-Gold-USB
• USB-link-adapter
– ADwin-Pro modules
• Pro-CPU-T9-USB
• Pro-USB
– ADwin-light-16
• EURO-ENET
• EXT-ENET
– ADwin-Gold
• ADwin-Gold-ENET
• Ethernet-link-adapter
– ADwin-Pro modules
• Pro-CPU-T9-ENET,
Pro-CPU-T10-ENET
• Pro-ENET
ADwin
⇒ chapter 2
⇒ one of the chapters
3...9
(see table below)
⇒ manual ADbasic
⇒ tutorial ADbasic
chapter
3: ADwin ISA link interface,
page 5
4: ADlink PCI adapter,
page 22
5: ADpcmcia adapter,
page 25
6: ADwin-light-16 system
with USB interface,
page 34
7: ADwin-Gold system with
USB interface, page 40
8: ADwin-Pro module with
USB interface, page 46
9: ADwin System with Eth-
ernet Interface, page 50
ADwin Installation, manual version 2.1, December 2005