AEG SLS 4705 Instruction Manual & Guarantee page 40

Buttons on the
Remote Control and Front Panel
1 ST.BY
Switches the system to the standby mode.
2 AC-3/5.1/2.1
Switches between AC3/DTS, 2.1 and
S 5.1.
3 MEMO 1-2-3
For selection of three preset volume levels.
Note: These preset values cannot be changed.
4 CEN (Center) +/-
With these buttons you can set the volume of the
center loudspeaker.
5 SUB (Subwoofer) +/-
With these buttons you can set the volume of the
subwoofer.
6 SUR (Surround) +/-
With these buttons you can set the volume of the
surround loudspeakers.
7 MASTER +/-
Buttons for volume adjustment.
8 MUTE
With this button you can switch off the loudspeakers
temporarily without changing the volume.
Note: When switching off this function ensure that the
overall volume is not set to maximum!
9 POWER
Mains switch
10 ST.BY
Standby lamp
11 Front +/-
These buttons are used to set the volume of the front
loudspeakers.
Note: Some buttons are located both on the front
panel of the device and on the remote control. The
buttons with the same designation have the same
function.
40
05-SLS 4705 AEG neu2 40
Initial Operation
Insert the plug in a duly installed 230V/50Hz socket.
1. Switch on your sound source (e.g. DVD player) and
start it.
2. Switch on the subwoofer with the on/off switch on the
front of the device.
3. Use the AC-3/5.1/2.1 button to select the desired
input source.
4. With the MASTER +/- button you can set the overall
volume.
5. By pressing buttons 4 to 6 on the remote control or
the corresponding buttons on the front of the subwoo-
fer, you can set the volume of the centre, surround
and subwoofer loudspeakers.
6. To stop operation, turn off the subwoofer with the
on/off switch.
Note: The surround and centre loudspeakers only work
when the system is turned to surround sound.
Technical Data
Model: ................................................................SLS 4705
Power supply: ................................................230 V, 50 Hz
Power outputs
L, R, C, LS, RS: ................................ 5 x 40 W PMPO
Subwoofer:............................................. 300 W PMPO
Signal-to-noise ratio:................................................. 60 dB
FST:
Transmitter
Power supply: .........................................................DC 5 V
Channels: ...................................................................... 16
Frequency range: ...............................2400 ~ 2483,5 MHz
Input level: ....................................................4 V pp (max.)
Output impedance: ...........................................> 10 kOhm
Receiver
Power supply: ................................................230 V, 50 Hz
Channels: ...................................................................... 16
Frequency range: ...............................2400 ~ 2483,5 MHz
Output impedance: .............................................< 1 kOhm
Crosstalk R/L: ........................................................> 15 dB
This device has been tested according to all relevant cur-
rent CE guidelines, such as electromagnetic compatibility
and low voltage directives, and has been constructed in
accordance with the latest safety regulations.
Subject to technical changes without prior notice!
14.02.2006, 9:02:37 Uhr