Getting Started - VTech Switch & Go Velociraptor Jet Instruction Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on
the bottom of the unit and use a
screwdriver to loosen the screw,
then open the battery cover.
3. Remove old batteries by pulling
up on one end of each battery.
4. Install 2 new AA (LR6/AM-3)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended.)
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
4