MTI ROGERS FREEDOM MICRO Installation Manual page 2

PROGRAMMING
Uploading Codes to Puck
1
Connect MCP to the Puck. The MCP beeps once. Puck LED will be
flashing.
Uploading Codes to Intellikeys
1
Connect the MCP to a Puck or other power supply (USB power supply or
PC USB port). The MCP beeps once when power is applied.
3
IF THE LED IS RED: Press the Function button on the MCP. The MCP
beeps once and each key's LED should then turn solid green.
MTI MTI 1050 NW 229th Avenue Hillsboro, OR 97124 T:800.426.6844 www.mobiletechinc.com
The MCP button may need
to be pressed more than
once to transfer the code.
Press
FREEDOM MICRO™ INSTALLATION GUIDE
2
Press and release the Function button. The MCP beeps once. Wait for
the second confirmation beep. Puck LED will still be flashing, but no
sound will come from the alarm.
2
Plug key(s) into the IntelliKey port(s) with the MTI logo facing down.
Wait for each key's LED to turn RED or GREEN.
4
IF THE LED IS GREEN: The key's existing code already matches the
current code in the MCP and no further action is required.
MTI P/N 063-1581-00 rev B ©2014 MTI All Rights Reserved
Press
The key LED may
take up to 6 seconds
to light up.
2