Xtech XTA311 Quick Installation Manual page 4

B. Installation with the extensions
Wide mode
1b-1. Use an open-end wrench to attach the brackets to the extensions with
the M6x10 screws (C) and the M6 nuts (D). Do not fasten too tightly as the
extensions will need some room to move inside or outside according to your
TV and soundbar setup.
1b-2. Select among the M4x14 (E) or the M5x14 (F) screws and the D5 metal
washers (H) to attach them to the brackets using a screwdriver. If you use the
M6x14 (G) screws you will not need to use the D5 metal washers for the
assembly.
E/F
H
C
D
G
XTA311
Depending on the soundbar, you might need to use instead the M6x14
screws (I) to attach the brackets to the soundbar. Then, use an open-end
wrench to place and fasten the M6 nuts (J) to the bracket and the soundbar.
Note: Depending on the holes of the brackets you will or won't need some
components as shown in the images below.
1b-3. If you select the M6x14 screws to attach the soundbar mount to the TV
wall mount, you will also need to use the two washers (R) as shown in the
image.
G
1
R
TV soundbar
mount
J
I
G
2