Replacing The Bar Bolt - Husqvarna Jonsered CS 2245 Workshop Manual

Repair instructions

7.29 Replacing the bar bolt

Replacing the front bar guide.
1
Drain the oil tank.
2
Knock through the old guide bar bolt so that it falls
into the oil tank.
3
Remove the bolt from the oil tank.
4
Secure steel wire to the outer part of the bar bolt
(A), thread the steel wire through the oil tank and
out through the bolt hole in the crankcase. (see
fi gure 69)
5
Pull the steel wire so the bolt comes out of its hole.
(see fi gure 69)
6
Check that the bolt's square head fi ts in
the washer (D) which is positioned in the cut-out in
the crankcase.
7
Pull out the bar bolt with its nut. Place a spacer
between the nut and crankcase. (see fi gure 69)
8
Refi ll with chain oil.
Replacing the rear bar guide
1
Pull out the bar guide (C) with the help of slip-joint
pliers. (see fi gure 68)
2
Fit the bar guide with the help of a hammer.
52
– English
Fig 68
Fig 69