Advertisement
Horizontal Installation
1.
Attach the bottom plate to the bottom of the speaker
using the included M5 × 16 screws for the DXR10, and
use the M8 × 35 hexagon bolts for the DHR10 and
CHR10, as shown in the figure below. The recommended
torque is 3 Nm for DXR10, and 12.4 Nm for DHR10 and
CHR10.
DXR10
M5 × 16 screw
DHR10, CHR10
The mounting position of the plate is sealed with screws,
so remove them (two total) with a 5 mm hexagon wrench
in advance.
M8 × 35 hexagon bolt
2.
Assemble two L-shaped brackets into a U-shape using
the included M5 × 10 screws as shown in the figure
below. Peel off the sheet from each rubber spacer, and
then attach the spacers to the inside of each bracket arm
by aligning the holes so that the hexagon bolts can be
inserted.
M5 × 10
M5 × 10
3.
Make sure that the width of the U-bracket matches the
speaker width.
4.
Affix the U-bracket on the wall or ceiling using appropri-
ate metal brackets and bolts. There will be a slight gap
between the U-bracket and the wall surface. Insert spac-
ers into the gap and affix them with bolts. These metal
brackets or bolts are not included in the package. If you
are not sure what to use to affix the U-bracket, consult a
specialist.
5.
For the DXR10, use the included hexagon bolts, M8
spring washers, and M8 flat washers to attach the
speaker to the U-bracket. For the DHR10 and CHR10,
use the included M8 × 35 hexagon bolts with spring
washer and flat washer to attach the speaker to the U-
bracket.
Use the bolt hole in the center of the handle on the top of
the speaker.
Hexagon bolt
Top
6.
Adjust the speaker angle, then tighten the bolts until the
speaker is securely affixed. The recommended torque is
12.4 Nm.
Installation Instructions
Hexagon
bolt
For DHR10, CHR10:
Use hexagon bolt with flat
washer and spring
washer
5
Advertisement
