Advertisement
Installation Instructions
CAUTION
Make sure that you do not pinch your fingers
between the U-bracket and speaker.
NOTE
(DHR10, CHR10 only) Carefully store the screws removed from the
speaker so that they are not lost. Using the speaker with the screws
removed will negatively affect sound quality due to air leakage
because the screw holes penetrate the inside of the speaker cabi-
net. Re-install the screws to the original screw holes after removing
the U-bracket.
Vertical installation
1.
Assemble two L-shaped brackets into a U-shape using
the included M5 × 10 screws as shown in the figure
below. Peel off the sheet from each rubber spacer, and
then attach the spacers to the inside of each bracket arm
by aligning the holes so that the hexagon bolts can be
inserted.
M5 × 10
2.
Make sure that the width of the U-bracket matches the
speaker width.
3.
Affix the U-bracket on the wall or ceiling using appropri-
ate metal brackets and bolts. These metal brackets or
bolts are not included in the package. If you are not sure
what to use to affix the U-bracket, consult a specialist.
4
M5 × 10
M5 × 10
4.
Use the included hexagon bolts (M8×25 for DXR10,
M8×55 for DHR10 and CHR10), M8 spring washers, and
M8 flat washers to attach the speaker to the U-bracket.
The mounting position of the speaker is sealed before
shipment, so remove the seal for DXR10, and remove the
M8 screws (2 total) for DHR10 and CHR10 with a 5 mm
hexagon wrench in advance.
DXR10
M8 × 25
hexagon bolt
DHR10, CHR10
M8 × 55
hexagon bolt
5.
Adjust the speaker angle, then tighten the bolts until the
speaker is securely affixed. The recommended torque is
12.4 Nm.
M8 × 25
hexagon bolt
M8 × 55
hexagon bolt
Advertisement
