This operation .manual contains all necessary information. Please read carefully to avoid damages and
faults. All rapid pieces of equipment are checked carefully before delivery for their perfect composition
and function. In case of improper use all rights to claim under guarantee are void.
Weiterentwicklung im Sinne des Fortschrittes behalten wir uns vor. - Technical Modifications are subject to change. - Details techniques subject à modification sans avis préalable
Translation of the original operation manual GB, Stand 01 / 2019
Page 1
This operation .manual contains all necessary information. Please read carefully to avoid damages and faults. All rapid pieces of equipment are checked carefully before delivery for their perfect composition and function. In case of improper use all rights to claim under guarantee are void.
· Please observe: This operation manual contains all necessary information. Please read carefully to avoid damages and faults. All Rapid pieces of equipment are checked carefully before delivery for their perfect composition and function. In case of improper use all rights to claim under guarantee are void.
Noiselevel (1m distance) 80db 4. Description The ABP 35 G12 and ABP 35 G24 are electrical Pumps suitable for urea, weak acid and weak alkaline fluid etc. or water. Pump: Self-priming, volumetric, diaphragm pump, equipped with by-pass valve. Motor: Asynchronous motor, single-ohase, 2 pole, closed type (Protectionclass IP 55 in conformance with EN 60034-5-86 regulations) self ventilated 5.
+49 (6158) 92980-0 plate. ATTENTION! The motors are not of an anti-explosive type ! Do not install them where inflamable vapours can be present ! Connecting - Before connection, make shure that the tubing and the suction tank are free of dirt and thread residue that could damage the pump and ist accessories.
+49 (6158) 92980-0 7. Operation 3.3 Working cycle 3.3.1 Extreme operating conditions with working cycles longer than 30 minutes can cause the motor temperature to rise, thus damaging the motor itself. 3.3.2 Each 30-minute working cycle should always be followed by a 30-minute power-off cooling phase.
+49 (6158) 92980-0 Problem Possible cause Corrective action Low or no ow rate The suction tubing is restung on the Raise the tubing bottom of the tank Increase pumpe noise Cavitation occuring Reduce suction pressure Irregular functioning ov the by-pass Dispense fluid until air is purged from the by- pass system Leakage from the pump body...