Advertisement
Schematics
Joystick 1
Select
Joystick 2
Up
Joystick 3
Down
CO
Menu buttons
TE
24 V
GND
dimensional drawings
Copyright HK Instruments 2017
Display connection
2
Terminal block
INSTALLATION
1) Mount the device in the desired location (see step 1).
2) Route the cables and connect the wires (see step 2).
3) The device is now ready for configuration.
WARNING! Apply power only after the device is properly wired.
STEP 1: MOUNTING THE DEVICE
1) Select the mounting location (on a duct).
2) Use the mounting flange of the device as a template and mark the
screw holes.
3) Mount the flange on the duct with screws (not included). (Figure 1a)
4) Adjust the probe to the desired depth. Ensure that the end of the
probe reaches the middle of the duct. (Figure 1b)
5) Tighten the screw on the flange to hold the probe in position.
Figure 1b - Mounting the probe in a flange
Air flow direction
Strain relief facing down
Air flow direction
www.hkinstruments.fi
Figure 1a - Mounting a flange
Tighten the
screw
Figure 1c - Mounting orientation
Air flow direction
Air flow direction
Air flow direction
Installation version 5.0 2017
Advertisement
