Remington Titanium SCC100 Manual page 6

HOW TO GIVE A HAIRCUT
1. Start at the back of the head. Holding the clipper as shown, lightly stroke upward making
2. Repeat the same procedure across the back of the head. Make sure the length of the hair
3. To cut the hair at the top of the head, cut from the front to the back in both directions
4. To trim around the ears and short hairs at the nape of the neck simply press the release
5. Make sure to check over the entire head for any uneven areas.
CARE FOR YOUR HAIRCLIPPER
1. The hair clipper shall be detached from the power supply cord before cleaning.
2. The hair clipper shall not be used until it has dried.
1. First remove the trimmer guard attachment from the clipper by pulling it fi rmly away from
2. For best results, you can remove the inside blade guard to expose the blades.
3. Then use the brush provided to sweep away hair clippings from the product.
4. This device can also be rinsed under the faucet to remove any remaining debris.
5. After cleaning is complete, reassemble the blade guard to the product by snapping into its
6. Reattach the comb to the product.
The life of your clippers will depend on frequency of use, care, and hair type and condition.
The Short Cut Clipper blades are lubed for life for your convenience. However, if you rinse
the product under running water, an oil bottle has been provided to re-oil the blades.
4
070961_REM_IFU_SCC100_INT.indd 4 070961_REM_IFU_SCC100_INT.indd 4
ENGLISH
sure you are taking off the desired amount of hair. Work your way up to the crown of the
head. When completed, move clipper over and cut down the head to the nape of the neck.
The SCC-100 is a bidirectional hair cutter so you can cut in either direction.
is trimmed to the same length on both sides of the head.
until the hair is cut to the desired length. (DIAGRAM C)
button for the pop-up detail trimmer. Be careful not to touch the ears or to press too
hard. (DIAGRAM D)
BEFORE YOU BEGIN
HOW TO CLEAN (DIAGRAM E)
the blades.
original position.
Note: After rinsing, the blades should be oiled for optimum performance and product life.
BLADE CARE
10.30.2007 7:47:43 Uhr 10.30.2007 7:47:43 Uhr