Suunto TANK POD User Manual page 11

Suunto Tank POD
NOTE: The battery level indication shown when pairing the Tank POD is an
approximation only.
6. Repeat the procedure above for additional Tank PODs and select different gases for each
POD.
Alternatively you can pair the Suunto Tank POD(s) from the menu:
1. Select which Tank POD to use with each gas by selecting a Tank POD for the gas in
question in the Gases menu.
2. Make sure the Tank POD has been activated by ensuring there is tank pressure reading
on screen and Tank POD green led is blinking. In the menu, the Tank POD is identified by
the serial number printed on the Tank POD.
In the dive main views, only one tank pressure is shown and corresponds to the active gas.
When the gas is changed, the displayed tank pressure is also changed accordingly.
WARNING: If there are several divers using Tank PODs, always check before you dive
that the POD number of your selected gas corresponds to the serial number on your POD.
TIP: Remove pressure from the Tank POD when not diving to save battery life.
For D5
To pair a Suunto Tank POD:
1. After installing the Tank POD and opening the valve, wait for green LED on Tank POD to
flash.
2. If your dive computer has a blank screen, press any key to activate it.
3. Use proximity pairing: Hold your dive computer close to the Tank POD. Make sure you
follow the instructions in 3.3. Tank POD alignment.
4. After a few seconds, a menu pops up on the screen showing the Tank POD serial number,
battery status and the tank pressure. From the menu, select the correct gas for that Tank
POD.
11