Checking The Battery And Operational Charging; Checking The Coin-Cell Battery - Lenovo ThinkPad Hardware Maintenance Manual

P1 gen 4 and x1 extreme gen 4
Hide thumbs Also See for ThinkPad:
Table of Contents

Advertisement

Ensure that you use the ac power adapter that is shipped with the computer to provide enough power to the
computer. Otherwise, a message will be displayed, prompting you that the computer will not be charged or
will be charged slowly.

Checking the battery and operational charging

Checking the battery
This system supports only batteries specially designed for this specific system and manufactured by Lenovo
or an authorized builder. The system does not support unauthorized batteries or batteries designed for other
systems. If an unauthorized battery or a battery designed for another systems is installed, the system will not
charge.
Attention: Lenovo has no responsibility for the performance or safety of unauthorized batteries, and
provides no warranties for failures or damage arising out of their use.
Move your pointer to the battery-status icon in the Windows
The battery-status icon displays the percentage of battery power remaining and how long you can use your
computer before you must charge the battery.
Checking the operational charging
To check whether the battery charges properly during operation, do the following:
1. Discharge the battery until the remained battery power is less than 50%.
2. Perform operational charging. Click the battery status icon in the Windows notification area to display
detailed battery information. If it indicates that the battery is not charging, replace the battery.
3. Check the battery status again. If the same error still exists, replace the system board.

Checking the coin-cell battery

To check the coin-cell battery, do the following:
1. Disable the built-in battery. See "Disabling the built-in battery" on page 60.
2. Remove the coin-cell battery. See "1160 System board and buzzer with cable" on page 85.
3. Measure the voltage of the coin-cell battery. See the following illustration.
• If the voltage is correct, replace the system board.
• If the voltage is not correct, replace the coin-cell battery.
• If the coin-cell battery discharges quickly after replacement, replace the system board.
®
notification area to check the battery status.
Wire
Voltage (V dc)
Red
+2.5 to +3.2
Black
Ground
.
Chapter 3
General checkout
29

Advertisement

Table of Contents
loading

Table of Contents