Advertisement
Quick Links
Shelf Storage
Cubby with
Three Baskets
Assembly and Use Instructions. Adult Assembly Required.
Read all instructions before use. This manual is part of the product
and must be saved for future reference.
MODEL NUMBERS*:
VERSION CODE*:
90801 - White
4.0/0419/TG
90811 - Pink
* Model and Version numbers are needed
90821 - Espresso
if replacement parts are requested
90831 - Gray
NOTE: Shelf Cubbies with Three Baskets
can be stacked/used with
Two Bin models and Three Bin models
(each sold separately - refer to our web site
for additional colors/models available).
ASSEMBLY TIPS! Review the entire manual before beginning.
Leave hardware slightly loose during assembly and then go back
and tighten fully at the end. If using a power screwdriver, keep
torque setting low and go slow to prevent damage to the product.
FOR REPLACEMENT PARTS:
http://www.badgerbasket.com/parts
Badger Basket®, PO Box 227, Edgar, WI 54426-0227 USA • Web: www.badgerbasket.com
U.S. Based Customer Service Toll-Free (Mon-Thurs 7:00 AM-4:00 PM CST): 1-800-236-1310
Phone: 715-352-2311 • Fax: 715-352-3163
4.0/0419/TG
Advertisement
Related Manuals for Badger Basket 90801
Summary of Contents for Badger Basket 90801
- Page 1 FOR REPLACEMENT PARTS: http://www.badgerbasket.com/parts Badger Basket®, PO Box 227, Edgar, WI 54426-0227 USA • Web: www.badgerbasket.com U.S. Based Customer Service Toll-Free (Mon-Thurs 7:00 AM-4:00 PM CST): 1-800-236-1310 Phone: 715-352-2311 • Fax: 715-352-3163...
-
Page 2: Before You Begin Assembly
BEFORE YOU BEGIN ASSEMBLY: Check all parts. If anything is missing or not satisfactory, please DO NOT call the store or return the product to them. Please go online to: http://www.badgerbasket.com/parts Most problems are resolved without you needing to leave home. When emailing or calling us, please have this instruction manual, your product model number, and your Version Code ready. - Page 3 NOTE: MAKE SURE THAT THE GROOVES ON PARTS (A), (B), AND (C) LINE UP BEFORE YOU TIGHTEN THE SCREWS. THE GROOVES MUST LINE UP SO THAT THE BACK (F) WILL FIT IN STEP 3 AND THE TOP (G) WILL ATTACH PROPERLY IN STEP 4.
- Page 5 NOTE: THE BACK (F) MUST BE SEATED INTO THE GROOVE ON THE THE BOTTOM (A) OR THE TOP (G) WILL NOT FIT PROPERLY. LOOSEN AND RETIGHTEN THE PANELS IF NEEDED SO THAT THE BACK (F) IS FITTED INTO ALL GROOVES PROPERLY AND THE TOP (G) FITS CORRECTLY.