Sony SU-WL500 Installation Manual page 13

Note
• Three or more people are required to detach the
Table-Top Stand.
• Be careful not to use excessive force while
detaching the Table-Top Stand from the LCD
Display as it may cause the LCD Display to fall
resulting in personal injury or physical damage to
the LCD Display.
• Take care when handling the Table-Top Stand to
prevent damage to the LCD Display.
• Be careful when lifting the LCD Display as the Table-
Top Stand is detached, the Table-Top Stand may
topple over and cause personal injury.
• Take care when removing the Table-Top Stand from
the LCD Display to prevent it from falling over and
damaging the surface that the LCD Display is sitting
on.
• Do not remove the Table-Top Stand for any reason
other than to install corresponding accessories on
the LCD Display.
• Be sure the LCD Display is vertical before turning
on. To avoid uneven picture uniformity do not
power on the LCD Display with the LCD panel facing
down.
Step 5:
Installing the LCD
Display on the wall
WARNING
Be sure to complete the installation before
connecting the AC power cord to the wall outlet. If
you allow the AC power cord to be pinched under
or between pieces of equipment, this may result
in a short circuit or an electric shock.
Be careful not to stumble over the AC power cord
or the LCD Display, as you may hurt yourself.
1
Install the LCD Display onto the
Base Bracket.
 Referring to the Screw and Hook locations
diagram/table on page 28, determine the
holes of the Base Bracket for latching the
upper hooks of the Mounting Hook.
 Hold the LCD Display securely with both
hands, and gently align it on the wall.
WARNING
• Be sure that two or more persons (three or more
persons for 85 inches and above LCD Display set)
hold the LCD Display when carrying it.
• When carrying the LCD Display, hold it in landscape
orientation, and take care not to drop it when
installing. Do not apply excessive force to the LCD
Display; otherwise, it may be deformed.
Mounting Hook
Base Bracket
13
(US)