Clemco CMS-3 Manual
  1. Manuals
  2. Brands
  3. Clemco Manuals
  4. Monitor
  5. CMS-3
  6. Manual

Clemco CMS-3 Manual

In-helmet carbon monoxide monitor
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
© 2015 CLEMCO INDUSTRIES CORP.
One Cable Car Dr.
Washington, MO 63090
Phone (636) 239-4300
F
(800) 726-7559
ax
Email: info@clemcoindustries.com
www.clemcoindustries.com
CMS-3
IN-HELMET CARBON MONOXIDE MONITOR
O. M. 24658
DATE OF ISSUE:
REVISION:
WARNING
Do not use this
equipment until you
have READ this
MANUAL and YOU
UNDERSTAND its
contents. *
These WARNINGS are
included for the health
and safety of the
operator and those in
the immediate vicinity.
*If you are using a Clemco Distributor
Maintenance and Parts Guide, refer to
the orange warnings insert preceding
the Index before continuing with the
enclosed instructions.
Electronic files include a Preface
containing important information.
January 2011
D, 04/15

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CMS-3 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Clemco CMS-3

Summary of Contents for Clemco CMS-3

  • Page 1 © 2015 CLEMCO INDUSTRIES CORP. the immediate vicinity. One Cable Car Dr. Washington, MO 63090 *If you are using a Clemco Distributor Phone (636) 239-4300 (800) 726-7559 Maintenance and Parts Guide, refer to Email: info@clemcoindustries.com the orange warnings insert preceding www.clemcoindustries.com...

  • Page 2: Table Of Contents

    Replacing the Charcoal Filter Disk ..12 ..5.4 injury. Troubleshooting ......... 13 ..6.0 Accessories and Replacement Parts ..14 ..7.0 © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...

  • Page 3: Specifications

    LCD. of CO during the last 15 minutes. Although some may find TWA and STEL information useful, it is not pertinent © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...

  • Page 4: Charcoal Filter Disc

    They are POWER/MODE and AIR. They Resets the alarm circuit (gas  turn on the power to the CMS-3 and turn it off. They alarms). control what is displayed on the LCD, including time, gas Enters Calibration Mode when ...

  • Page 5: Lithium Battery (A Spare Is Included)

    Don the helmet to make sure the monitor’s alarm-lights visible from inside helmet. 2.1.2.4 Remove the monitor and prepare it for operation. © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...

  • Page 6: Turning On And Start-Up Procedure

    Before using the CMS-3, set the fresh air reading to shown in military format with the hour going from 0 to 24. ensure accurate gas readings in the monitoring environment. Refer to Section 4.1 © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...
  • Page 7 POWER/MODE button once, after the CO reading falls button to enter Peak Display Mode. Press and release the below the low alarm point. POWER/MODE button again to enter STEL Display Mode. © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...
  • Page 8 (Double Pulse). • Gas reading replaced by FAIL. Audible alarm beeps twice per  System Failure • Time replaced by SYS below FAIL second (Double Pulse). Figure 6 © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...

  • Page 9: Measuring Mode

    POWER/MODE button to save the new setting. The next twice per second beep and stresses the urgency to alarm point will be displayed. remove the respirator as soon as it is safe to do so. © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...

  • Page 10: Setting The Clock

    • Calibration connector with tubing and calibration cup. 4.2.2.1 Make sure the monitor is off. 4.2.2.2 Make sure the calibration connector valve is closed, and then attach the connector to the test gas cylinder. © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...
  • Page 11 Press and hold the AIR button, then press and 4.3.5 was not successful, the display will read FAIL. hold the POWER/MODE button. Release both buttons © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...

  • Page 12: Maintenance

    Carefully remove the old sensor from the sensor 5.2.4 the cover away from the bottom case. The screws are socket. NOTE: The sensor is keyed and can only be © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...

  • Page 13: Replacing The Charcoal Filter Disk

    Install a new sensor cover into its recess in the 5.4.6 sensor gasket. Reinstall the sensor cap, making sure both tabs 5.4.7 snap into place. Figure 11 © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...
  • Page 14 Turn off the unit and turn it on again. indicated on the 2. If the difficulties continue, contact an authorized LCD. Clemco distributor for further instructions. Figure 12 © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...

  • Page 15: Accessories And Replacement Parts

    Filter, charcoal, pack of 5 ......25564 Mounting plate ........... 25575 Battery, Lithium, ......... 24619 or purchase locally ....Model CR2450 OP E N CLEMCO STK# 24613 Figure 13 Figure 14 © 2015 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 24658, Rev. D...

Table of Contents