Valcom VE8006R Quick Start Manual

INTRODUCTION
The VE8006R IP Admin I/O Module allows most
loop start terminal devices to be connected to a
managed IP-based LAN/WAN. The VE8006R is
made specifically for rack mounting (1U).
SPECIFICATIONS
Access Methods

PBX, FXO Port

POTS telephone set
Features

RJ-45 for network connection

4 Relays with Form A contacts

Activity LED

Network activity LEDs

2 RENS

2.5mm jack for external power
Dimensions/Weight

1 Standard 19" Rack Unit

1.75" H x 16.50" W x 5.25" D
(4.45 cm x 41.91 cm x 13.33 cm)
Weight: 5.10 lbs. (2.32 kg)
Nominal Specifications
Input Impedance:
Input Level:
Output Impedance:
Output Level:
Relay Current:
Nominal Power Requirements
Via rear panel barrel connector:
Voltage:
Current:
Power Supply Included
Environment
Temperature:
Humidity: 0 to 85% non-precipitating
VE8006R
IP ADMIN I/O MODULE
600 Ohms
-10dBm
600 Ohms
- 10dBm nominal
1 AMP @ 24VDC
24VDC
1 AMP
0 to +40° C
1
These products are intended for use with a UL
Listed power source marked "Class 2" or "LPS"
rated 24VDC.
Precautionary Designations
:

WARNING To Reduce The Risk Of Fire
Or Electric Shock. Do Not Expose This
Apparatus To Rain Or Moisture.

AVERTISSEMENT: Afin de réduire les
risques d'incendie ou de décharge
électrique, évitez d'exposer le système à
la pluie ou à l'humidité.

Apparatus shall not be exposed to
dripping or splashing and no objects
filled with liquids, such as vases, shall be
placed on the apparatus.

L'appareil ne doit pas être exposé à des
égouttements et éclaboussures et
aucun Objet Rempli de liquide, comme
vase, ne doit être placé sur l'appareil.
NOTE: The telephone system referred to in
this manual is the customer premise
equipment such as an electronic key system,
a PBX or a dedicated single line telephone
sets. The VE8006R is not intended for direct
or indirect connection to the public telephone
network. When used with a customer premise
telephone system such as a key system or
PBX system, these units are interfaced to the
system via a fully protected system central
office port, which is a fully protected interface
device. Also, the host system must be
configured to disallow central office trunk
conferencing in order to prevent indirect
connection to the public network.
A detailed Programming manual is available
at www.ValcomES.com
Issue 3
947490