Before Your First Use; Using The Waffle Maker - Philips KB5500 Instructions For Use Manual

Before Your First Use:

Carefully unpack the waffle maker and remove all packaging
materials. Set the waffle maker on a clean, dry counter or table.
The non-stick cooking surfaces may be wiped with a clean, damp
cloth or sponge. Do not use abrasive cleansers, as this will
damage the cooking surfaces. The exterior may be wiped with a
clean, damp cloth. Do not immerse the unit, cord or plug in
water or other liquid.
Before heating your waffle maker, the cooking surfaces may be
sprayed or brushed with a small amount of non-stick spray or
cooking oil. To protect the premium quality non-stick surface of
your waffle maker, be sure to use only plastic, nylon or wooden
utensils.
The first time you use your waffle maker, a small amount of
smoking may occur. This is quite normal for new appliances and
will disappear after one or two uses.
the Waffle Maker:
Using
1. Prepare the cooking surfaces of the waffle maker by lightly
brushing or spraying them with cooking oil or non-stick spray.
Note" The first waffle may appear slightly dark because of this oil.
2. Plug the unit info a 120V 60Hz AC only outlet. Close the cover
to allow the unit to heat faster. The indicator light on top of the
waffle maker will come on indicating that the unit is now
heating.
3. When the indicator light goes off, the waffle maker will be at the
ideal temperature for baking waffles. Raise the cover and pour
1/2 cup of your favourite waffle batter from a cup or pitcher onto
the center of the cooking surface. Close the cover of the unit. A
small amount of batter may run down the sides and front of the
unit. If an excessive amount of batter runs out, reduce the
amount of batter used.
4. Do not open cover for first minute of cooking. This may cause
sticking or splitting of waffles.
5. The waffle will require approximately 3 minutes to bake. During
baking, the batter will rise and steam will escape from the sides