Warming drawer and warming drawer cabinet (10 pages)
Summary of Contents for Lynx L30WD-1
Page 1
MAKE THE MOST OF YOUR L30WD-1 (Pictured) L42CC-1 Warming Drawer / Warming Drawer Cabinet CARE & USE/INSTALLATION LCS30 COCKTAIL STATION CARE & USE/INSTALLATION...
Contact our Preferred Customer Service facility for information or additional details. 22. Do not repair or replace any part of this warming drawer. All servicing should be done by an authorized service agency. Contact Lynx Customer Service at 1-888-289-5969 23. Save these instructions for future reference.
9. Do not use the warming drawer for purposes other than intended. 10. Do not operate the warming drawer with a damaged cord, plug or after the appliance malfunctions, or has been damaged in any manner. Contact Lynx Customer Service for repairs. 1-888-289-5969 WARNING: ELECTRICAL SHOCK HAZARD This appliance is equipped with a 3-prong power cord with a grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded receptacle.
Page 5
10” 20-1/2” 11-1/2” Typical Island Installation L30WD-1 Provide a 10” x 28 ½” cutout to the front of the island. 2. Provide support beams using metal studs. 3. Pull the drawer out of the drawer casing to gain access on the mounting holder at the front of the casing.
Page 7
Installing the Warming Drawer w/Cabinet L42CC Cutout Dimensions Model (Width) (Height (Depth) L42CC 40-1/4” 19-3/8” 24-3/4” 21” 120 V Electric Outlet Needed Typical Island Installation L42CC Provide a 19 3/8” x 40 ¼” cutout to the front of the island. 2.
Before Using Your Appliance All products are wiped clean with solvents at the factory to remove any visible signs of dirt, oil, and grease which may have remained from the manufacturing process. Before using, clean the drawer thoroughly with hot, soapy water. There may be some burn off and odors on fi...
Part of the appeal of your Lynx Accesory is the fine grain finish. When removing stubborn stains: • Do not use metallic abrasives and always rub in the direction of the grain. • Some household cleaning products are not suitable for stainless steel; be sure to read the label before using on your Lynx Accesory.
Cleaning and Maintenance Cleaning Chart Material Recommendations Drawer interior (stainless steel) Use dish detergent. Wash, rinse well and dry. For hard water spots or scales, use white vinegar. Apply with a sponge or cloth, rinse, and dry. Heat Discoloration / Corrosion: Clean with BarKeeper’s Friend®...
2 WIRE GROUNDED SINGLE PHASE For warranty service, contact Lynx Customer Care for an authorized service agent near you by calling (888) 289-5969 or online at www.lynxgrills.com. Your satisfaction is of the utmost importance to us. If a problem cannot be resolved to your...
Wiring Schematic White Wire Green to Ground To Heat Coil To Heat Coil To Heat Coil NOTE: All Connections Crimped Secure. To LED Light To Thermostat L30WD/L42CC Use/Install Manual...
No one has the authority to add to or vary Lynx’s regular use. This warranty is limited to the replacement of warranty, or to create for Lynx any other obligation or the defective parts, with the owner paying all other cost liability in connection with the sale or use of its products.
THIS PROVISION EXCLUDES ALL COMMERCIAL which vary from state to state. APPLICATIONS, INCLUDING, BUT NOT LIMITED TO No one has the authority to add to or vary Lynx’s RESTAURANTS AND INSTITUTIONAL FOOD SERVICE warranty, or to create for Lynx any other obligation or LOCATIONS.
Need help?
Do you have a question about the L30WD-1 and is the answer not in the manual?
Questions and answers