Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ToolPRO HM80L
Summary of Contents for ToolPRO HM80L
- Page 1 HM80L Undercut Mitre Saw Instruction Manual PLU XXXXXX...
- Page 2 Fig. 1 Fig. 1.2 Fig. 2 Fig. 3 Fig. 4...
-
Page 3: Explanation Of The Symbols On The Equipment
Fig. 5 Fig. 6 Explanation of the symbols on the equipment Caution - Read the operating instructions to reduce the risk of inquiry Wear safety goggles! Wear ear-muffs! Protection class II... -
Page 4: Dear Customer
HM80L MANUFACTURER: Scope of delivery Made in China Undercut Mitre Saw dust collector bag DEAR CUSTOMER, workpiece holder we wish you a pleasant and successful working experi- tooling for sawblade change SW 6 ence with your new machine. 3 supports... -
Page 5: General Safety Notes
• Try to keep exposure to vibration to a minimum. Ex- • Switch off the machine when troubleshooting. Unplug amples of ways to reduce vibration levels are wearing the machine. gloves when using the tool and limiting working hours. • Installation, repair and maintenance work on the elec- In doing so, all parts of the operating cycle must be trical installation may only be carried out by qualified taken into account (for example, times in which the... - Page 6 • Inspect extension cords regularly and replace them if • Warning: Do not remove cuttings or other parts of the they are damaged. workpiece from the cutting area while the machine is • Avoid accidental starting of the machine. running and the saw has not yet come to a comple- •...
-
Page 7: Proper Use
m Proper use blade and a decrease in performance in terms of finish and cutting precision. CE tested machines meet all valid EC machine • When cutting aluminium and plastics always use the guidelines as well as all relevent guidelines for each app ro priate clamps: all workpieces must be clamped machine. - Page 8 Start-up ADJUSTING Observe the safety notes in the operating instruc- ATTENTION: All the adjustment procedures illustrated tions before operating the machine. below must be performed when the machine‘s engine is off. REMOVAL OF PACKAGING Cross-cutting Operation: Remove the box used to protect the machine during trans portion and keep it intact for future transportation Swiveling the Table Top (Fig.
-
Page 9: Electrical Connection
Changing the saw blade (Fig. 5) Single-phase motor • Pull the power plug. • The mains voltage must coincide with the voltage • Put the sawing unit in the upper position. specified on the motor’s rating plate. • Release the movable saw blade guard (11) by press- •... -
Page 10: Disposal Of The Machine
ATTENTION: Do not use compressed air jets! • Regularly check blade conditions: if difficulties should arise during cutting, have it sharpened by skilled per sonnel or replace it if necessary. ASSISTENCE When in need of skilled personnel for special maintenance, or for repairs, both during and following the guarantee pe riod, always apply to authorized centres for assistance or directly to the manufacturer if there is no authorized centre in your area. - Page 12 HM80L Undercut Mitre Saw Instruction Manual Manufactured and packaged for SRGS PTY LTD ABN 23 113 230 050 751 Gympie Road, Lawnton, Queensland 4501, Australia...
Need help?
Do you have a question about the HM80L and is the answer not in the manual?
Questions and answers