Table of Contents
Advertisement
GETTING STARTED
3
4
Insert the lower vacuum tube into the upper vacuum tube
Pull the locking pin.
until it snaps in place.
9
10
1
2
Pull the quick release tab to easily remove the harness
Install the battery pack.
from the product.
GETTING STARTED
5
Install the vacuum tube assembly into the housing.
NOTE: Make sure that the locking pin is inserted into the upper tube, locking the tube assembly in place.
11
LOW
Set the speed switch to the preferred speed.
NOTE: The speed can be set to LOW or HIGH.
GETTING STARTED
6
Turn the thumbscrew clockwise until it snaps in place and
is fully tightened.
The product will not start if the thumbscrew is not fully
tightened.
12
HIGH
Squeeze the trigger to start the product.
WARNING: Never operate the vacuum with only the
upper vacuum tube fitted. Failure to follow this warning
increases the risk of personal injury.
Hold the product by the designated handles and operate
the product in the recommended position as shown. The
wheels work best when used on a flat surface such as a
concrete patio or sidewalk.
11
Advertisement
Table of Contents
