Replacing Carbon Brushes - Makita 8406C Instruction Manual

Replacing carbon brushes

Fig.24
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
Fig.25
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Tungsten-carbide tipped hammer bit
•
Diamond core bit (Dry type)
•
Center bit
•
Center bit shank
•
Diamond core bit (wet type)
•
Guide ring
•
Sheet
•
Sponge
•
Water protection collar
•
Blow-out bulb
•
Safety goggles
•
Chuck key
•
Side grip
•
or attachments
Only use accessory or
are
9