Advertisement
4.10.
now bolt the whole steering assembly to the bed. Use two
8 x 20mm bolts to fix the front axle support at points 'B' x 2 and
two 8 x 20mm bolts to fix the centre brace at point 'd'.
4.11.
Slide wheel spacer bushings onto both the front and rear
axles. Place a wheel onto each axle with the valve stem facing
outwards. Place a plain washer onto each axle followed by spring
washer and secure each wheel with a locking nut.
4.12.
Turn the cart upright onto its wheels and attach the pull handle
using the plastic coupling. Secure with the 8 x 60mm pull handle
bolt, washer and nut.
4.13.
Attach each hinged side-piece to the bed using the quick release
pins provided (See fig.4-A). Attach the side with the cut out
portion to the handle end of the bed. (See fig.3)
4.14.
To raise and lock the sides of the truck lift one end-piece first and
move the locking handle (see fig.4-B) into the vertical position.
Raise the adjacent side-piece so that the locking handle passes
through the slotted tongue on the side-piece. now swing the
handle downwards to lock the side-piece in position (see fig.5).
Repeat the process for all four corners so that the truck is
assembled as shown in fig.6.
5. truck oPeratIon
5.1.
Check tyre pressures on the truck on a regular basis. Do not inflate above
30psi.
Do not overload the truck and ensure that the load is evenly distributed before
8
setting off.
5.2.
When towing the truck proceed at a safe speed especially at corners where
there could be a danger of the load shifting.
5.3.
When using as a flat bed truck Do not transport loads with an excessive
overhang.
5.4.
extra care should be taken on inclined surfaces.
5.5.
If the truck is loaded and left unattended the wheels should be chocked.
5.6.
Where there is a curb or step a ramp should be used.
5.7.
When using as a flat bed truck remove all sides so as not to restrict the turning
circle.
enVIronment ProtectIon
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, kempson Way, Suffolk business Park, bury St edmunds, Suffolk. IP32 7ar
01284 757500
© Jack Sealey limited
fig.4
01284 703534
sales@sealey.co.uk
Original Language Version
fig.5
www.sealey.co.uk
CST997.V2 Issue 2 (HF) 15/10/18
fig.3
fig.6
Advertisement
