Table of Contents
Advertisement
Quick Links
READ THIS SHEET FIRST
READ THIS SHEET FIRST
Thank you for purchasing the Canon imageCLASS MPC190.
To get your machine ready for use, please follow the instructions in this Setup Sheet
before referring to any other documentation.
Unpack the machine and its components.
Check that you have the following:
Machine
Printhead
NOTE
• A printer cable is not included. You must purchase a USB cable (less than 5 m/16# / 8 ft.) to
connect your machine to a computer.
• Please note that the items included with your machine may vary depending on the
country of purchase.
Setup Sheet
Setup Sheet
Multi-purpose tray
Power cord
Documentation
(Setup Sheet, Basic Guide)
MultiPASS Suite software CD-ROM
Ink tanks
(Black, colour)
Advertisement
Table of Contents
Related Manuals for Canon MultiPASS MPC190
Summary of Contents for Canon MultiPASS MPC190
- Page 1 Setup Sheet READ THIS SHEET FIRST READ THIS SHEET FIRST Thank you for purchasing the Canon imageCLASS MPC190. To get your machine ready for use, please follow the instructions in this Setup Sheet before referring to any other documentation. Unpack the machine and its components.
-
Page 2: Remove The Shipping Materials
Remove the shipping materials. Place the machine on a flat surface. Remove all shipping tapes from the exterior of the machine. NOTE • DO NOT remove the USB label A at this stage. USB label A Attach and close the multi-purpose tray. Connect the power cord. -
Page 3: Load Paper
Load paper. Open the multi-purpose tray Place a stack of paper (print side up) in the multi-purpose tray q and adjust the paper guide A to the width of the stack w. Make sure the stack does not exceed the paper limit mark B. NOTE •... -
Page 4: Install The Printhead
Install the printhead. IMPORTANT • To turn off the machine, be sure to always press [ON/OFF]. This will ensure that the printhead is capped and prevent it from drying up. • If you are not using the machine for a long period of time, we recommend that you print (in black and colour) or clean the printhead approximately once a month to maintain the printhead in good working condition. -
Page 5: Install The Ink Tanks
Install the ink tanks. Start with the black ink tank. Remove the ink tank from its packaging, hold it as shown below, then remove the protective cap A. Insert the black ink tank into the right hand slot. Press firmly on the ink tank‘s tab until it clicks into place. -
Page 6: Align The Printhead
Align the printhead. NOTE • If you will be installing the MultiPASS Suite software, you can also align the printhead from the software. For details, see p. 8-7 of the Basic Guide. When the LCD A displays the following, press [OK]. A L I G N P R I N T H E A D P R E S S O K K E Y The machine will print a horizontal pattern, and the LCD will display:... -
Page 7: Install The Software
Install the software. IMPORTANT • DO NOT connect the USB cable before installing the software. NOTE • Windows 98/Me users: You need to have “Client for Microsoft Networks“ installed before installing the MultiPASS Suite software. For details, refer to p. 9-1 of the Basic Guide. •... - Page 8 MultiPASS Suite software, refer to the Software Guide (included in the CD-ROM). Part no. HT3-2128-000-V.1.0 © 2003 Canon Inc. Canon, MultiPASS, imageCLASS, and BCI are trademarks of Canon Inc. All other products and brand names are registered trademarks or trademarks of their respective owners.