Download Print this page

Jensen of Scandinavia HL3200 Faq

The HL3200 uses the powerlines in your house to transmit and receive data.

In your HL3200 package there are two devices that are pre-connected to each other.

Easily explained HL3200 replaces a network cable from A to B.

HL3200 works very well most places, but it still depends on how the power wiring

is set up, and the quality of it.

1) Setup

Connect one of the HL3200 in a wall socket close to where you have your internet

router. Connect a network cable between HL3200 and one of your routers LAN ports.

Now connect the other HL3200 in a wall socket where you would like to have access

to the internet. Connect a network cable between this second HL3200 and the

network device.

Placement

We recommend that HL3200 is plugged directly into the wall socket.

Avoid the use of any extension cords.

HL3200 ABC

1 - Setup and placement

3 - Reset and pairing

4 - How to add a new HL3200

FAQ - Spørsmål og svar

Table of Contents

Do you have a question about the HL3200 and is the answer not in the manual?

Page 1 4 - How to add a new HL3200 1) Setup Connect one of the HL3200 in a wall socket close to where you have your internet router. Connect a network cable between HL3200 and one of your routers LAN ports.
Page 2 3. Network. Show network connection status. On successful connection, all LEDs will look like the below picture. If the Connection LED(2) is not ON, the HL3200 is not correcly paired, or your devices are not able to establish a connection.
Page 3 HL3200v1 HL3200v2/HL3200F Pairing In order for the HL3200 devices to encrypt traffic between them, they need to be paired together. 1. Put the two HL3200 devices in separate wall sockets and wait until they have started (Unti power LED is ON) 2.
Page 4 You can have up to 10 pcs. of HL3200 connected in your home. To add a new HL3200 just connect the new idevice n an available wall socket and press the «Connect» button for 2 seconds. Then do the same on one of your existing HL3200 devices.