Fastening The Power Bricks And Routing The Cable - Black Box LCC30H-A User Manual

4.2 Fastening the Power Bricks at the Back of the Cart
1. Attach the wrapped cord and power brick to the back of the shelf using the
hook and loop strap. Keep some extra cable unwrapped to plug into the power
strip. (See Figure 4-2.)
2. Loosen the two screws on the cable manager, pull up on the top section of the
cable manager, and place the device side of the charging cable into one of the
slots.
3. Replace the top section of the cable manager and tighten the screws.
4. Route the device side of the charging cable to the front of the cart and repeat
step 2 for the front cable manager (see Figure 4-3).
5. Plug the charger power plug into the power strip located below the shelf.
Cable
manager
Power brick
and cord
Figure 4-2. Fastening the power brick and routing the cable.
LCC30H-A
724-746-5500 | blackbox.com
Chapter 4: Configuration and Setup
Route cable to the
front of the cart
Power
strip
Loosen screws on
cable manager and
pull up
Page 11