Lux Products LP1513 User Manual

USER MANUAL
LP1513
Rechargeable LED Lantern
With Diffused Lens
3
USB
C
Batteries
Rechar geabl e
Not Included

Features

Dual battery design
Rugged-durable rubber design
Di used lens
360° LED technology
Power bank to charge other devices
Variable on/o brightness dial
IPX4 waterproof rating
ANSI/PLATO FL1 STANDARD
MODES LUMENS
10650, 3.7V 2000mAh Rechargeable Battery
High
878 lm
Low 62 lm
Internal Battery & 3 C Cell Batteries*
High 942 lm
Low 64 lm
BEAM
RUN TIME DISTANCE
1h 45m
30m
11h 8m
3h 15m 30m
155h 30m 6m

Operation Instructions

On/O : Turn the dial on the front of the lantern clockwise to turn
the light on. Turn the dial counterclockwise completely to turn the
light o . There will be an audible click when turned on or o .
Adjust Brightness: Rotate the dial clockwise to increase the
brightness, and counterclockwise to decrease the brightness.

Charging Instructions

Plug the supplied USB cable into the smaller USB port on the left.
Plug the opposite end of the cable into a USB power source.
A red LED light in the charge port will light up to indicate the
3
lantern is charging. The light is fully charged once the light turns
green.
3
The lantern will turn on and can be used while charging.
The LP1513 has a charge time of approximately 3 hours.

Charging Other Devices:

ANSI/PLATO FL1 STANDARD
The LP1513 can also be used as a power bank to charge other
devices.
To use as a power bank, plug the large end of your charging cable
into the larger USB port on the right, and plug the opposite end of
the cable into your electronic device.
While the lantern is on, it will not charge other devices. If the
lantern is turned on while charging a device, it will stop charging
the device until the light is turned o .
luxpro.com
866.553.8886
Charging Product:
The LP1513 uses a Li-poly: 3.7V
2000 mAh rechargeable battery.
To charge the lantern, locate the
USB dust cover below the power
dial. Lift the cover to expose the
two charging ports.
14725 S Porter Rockwell Blvd Ste C
Bluffdale, UT 84065