Operation; Pat Testing - Prem-I-Air EH1432 Instructions Manual

OPERATION

Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead
is rated at 10 Amps or more, and that it is fully unwound.
Switch the unit on at the mains socket.
Open the door and use the three switches to select the
required operation:
• For flame effect only, put the ON/OFF switch in the ON
position, and the other two switches OFF
• For low heat, put the ON/OFF switch and the I switch in the
ON position, and the other switch OFF
• For high heat, put all three switches in the ON position.
Do not touch the air output grille when the heater is in
operation, because it will be hot and may cause burns.
Unplug the heater from the mains when not in use.
OPERATING COSTS
At time of going to press, the average cost of electricity is
£0.11 per unit (kilowatt-hour). The amount you are being
charged will be shown on your electricity bill.
At this cost, the EH1432 will cost £0.16 per hour to run on the
high heat setting, or £0.08 per hour on the low heat settingz.
On the "flame effect only" setting, the EH1432 will cost 1p
per hour to run.

PAT TESTING

When used in an office environment, this product must be
safety-tested yearly by a qualified electrician (PAT Tested) in
order to comply with the Electricity at Work Regulations.
It is good practice that appliances are regularly PAT tested
when used in a domestic environment.
Page 3