Table of Contents
Advertisement
Before cleaning, turn the appliance off, and disconnect from
the mains supply. The appliance may then be cleaned using
a damp cloth with a drop of washing-up liquid to remove any
dust or dirt from the case. Do no use stronger detergents or
solvents as these may damage the paint finish.
Cleaning the filters:
The filters are located on the side panels of the appliance.
Unclip the grille and slide out the filter, then remove dust and
dirt using either a vacuum cleaner or a compressed air
blower. The filter should be cleaned every two weeks to
maintain optimum performance.
Using a dry 1" (25mm) paint-brush, remove any dust from
the grilles.
Use a compressed air blower to remove dirt and dust from
the heat exchangers.
If the mains lead is damaged, it must be replaced by the
the terminal labelled with the earth symbol or "E".
• Make sure that the cord-grip is positioned correctly (over
the outer sheath of the cable) and it fully tightened.
MAINTENANCE
manufacturer
service centre. If the mains plug
needs to be replaced, proceed as
follows:
• Connect the brown wire to the
terminal labelled "L".
• Connect the blue wire to the
terminal labelled "N".
• Connect the green/yellow wire to
Page 8
or
an
authorised
Advertisement
Table of Contents
