Advertisement
3
Plug the male side of one male to female IR cable into the IR In connector
on the OUTPUT side of the extender box.
4
Plug the female end of the cable into the male end of the IR sensor that
came with your Matrix Video Wall. If the Quad controller module is
powered on, you should now see a green IR LED on both sides.
Plug this end into the
male end of the IR
sensor cable.
Note:
For larger walls greater than four displays, the IR sensor is only hooked up to the
extender box associated with Quad controller module A.
Connecting the Matrix Video Extender Box
Plug this end into
the IR connector of
the OUTPUT side
of extender box.
3
Advertisement
