Whirlpool UW8 F1C WB NF Instructions For Use Manual page 86

8.2. FAILURES
In the event of operation alarms, they will also be displayed in the digits LEDs, (e.g. Failure1, Failure 2, etc...) call
After-sales Service and specify the alarm code. The acoustic alarm sounds, the Alarm icon
letter on the digit display blinks according to failure code described below:
Failure code
Error 2
Error 3
Error 6
9. AFTER-SALES SERVICE
Before contacting After-Sales Service:
Switch the appliance on again to see if the problem has been solved. If it has not, disconnect the appliance from
the power supply and wait for about an hour before switching on again.
If, after performing the checks described in the Troubleshooting Guide and switching the appliance on again, your
appliance still does not work properly, contact the After-sales Service, explain the problem.
Specify:
• the model and appliance serial number (stated on the rating plate),
• the nature of the problem,
• the Service number (the number after the word SERVICE on the data plate on the inside of the appliance),
• your full address,
• your telephone number and area code.
Note:
The direction of door opening can be changed. If this operation is performed by After-sales Service it is not
covered by the warranty.
F letter blink on/off at 0,5 sec. Blinks ON 2 times
then remain off for 5 seconds. Pattern repeats.
F letter blink on/off at 0,5 sec. Blinks ON 3 times
then remain off for 5 seconds. Pattern repeats.
F letter blink on/off at 0,5 sec. Blinks ON 6 times
then remain off for 5 seconds. Pattern repeats.
Visualization
86
lights up and the F
x2
x3
x6