Table of Contents
Advertisement
Reassembly
Install Breather Components
D
F
A
Breather Hose
C
Breather Cover
E
Breather Filter
G
Reed Retainer
Breather Cover Fastener Torque Sequence
1 & 5
4
96
A
B
C
E
G
H
Breather Hose
B
Insulator
Breather Cover
D
Gasket
F
Breather Reed Screw
H
Breather Reed
3
2
KohlerEngines.com
1. Make sure sealing surfaces of crankcase and
breather cover are clean and free of all old gasket
material. Clean with an aerosol type gasket remover
or cleaning solvent. DO NOT scrape surfaces as this
can result in leakage.
2. Check to make sure there are no nicks or burrs on
sealing surfaces.
3. Install breather reed and breather reed retainer onto
crankcase and secure with screw. Hold assembly in
line when tightening. Torque screw to 4.0 N·m
(35 in. lb.).
4. Install breather fi lter into cavity in crankcase.
5. Carefully install breather cover gasket and breather
cover onto crankcase.
6. Install and torque four breather cover screws to
10.7 N·m (55 in. lb.) into new holes, or 7.3 N·m (65
in. lb.) into used holes, in sequence shown.
7. Install Oil Sentry
switch into tapped breather port if
™
removed earlier. Apply pipe sealant with Tefl on
(Loctite
PST
592™ Thread Sealant or equivalent)
®
®
to threads. Torque to 4.5 N·m (40 in. lb.).
Install External Governor Controls and Main Control
Bracket
Details
A
I
H
G
F
E
A
Control Bracket
C
Throttle Linkage
E
Governor Lever
G
Governor Lever Nut
I
Throttle Limiter Spring
1. Install governor lever onto governor cross shaft. If
separated, connect throttle link to governor lever
with plastic bushing. Hook dampening spring into
small (middle) hole.
2. Move governor lever TOWARDS intake manifold as
far as it will go (wide open throttle) and hold in this
position.
®
B
C
D
B
Linkage Spring
Linkage Retaining
D
Bushing
Governor Lever
F
Screw
H
Governor Spring
66 690 14 Rev. A
Advertisement
Table of Contents
