Use Of The Product - Chacon 34234 User Manual

4. Use of the product

Mode
The device is working
correctly
The device is in "test" mode
The device has detected
smoke
The battery is low
The device is not working
correctly
4.1. Battery low
When the battery is low, the smoke detector warns you by emitting a repetitive beep and
flashing for around 30 days. Replace the batteries with one of the types recommended in the
paragraph on "Technical specifications"
- Remove the smoke detector from mounting bracket by turning it anticlockwise.
- Install the new battery as shown in point 1. Introduction to the product
- Test the alarm using the test button every time you change the battery.
4.2. Fault warning mode
If the smoke detector is not working properly, it moves into "fault warning" mode. Attempt
to clean the smoke detector (see maintenance). If you do not see any improvement and it
remains in fault mode, replace the smoke detector!
LED signal
1 x every 32 seconds
1 x every second 3 times,
with a 1.5 second pause
between each flash
1 x every second 3 times,
with a 1.5 second pause
between each flash
1 x every 32 seconds
1 x every 32 seconds
Sound signal
None
1 x every second 3 times,
with a 1.5 second pause
between each beep
1 x every second 3 times,
with a 1.5 second pause
between each beep
1 x every 32 seconds
1 x every 32 seconds