Dip Switching Setting; 485 Termination; Protocal; Baud Rate Setting - CBC Ganz ZT-WD Series Instruction Manual

DIP Switching Setting

(SW1) TERMINAL 4
(SW2) Camera ID
A. 485 Termenation
th
The 4 of DIP SW1 is used for 100Ω termination.
Set the termination on the last looped camera on the entire system.
B. Protocal
rd
The 3 of DIP SW1 above are used for protocol setting.
C. Baud Rate Setting
st nd
The 1 , 2 SW of DIP SW1 above a used for BAUD RATE setting.
DIP SW can be changeable to 4,800bps, 9,600bps.
Factory default : 2,400bps
Note!!
DIP SW1 - 1 st
OFF
ON
OFF
ON
BAUD RATE 1
BAUD RATE 2
PROTOCOL 3
CAM 1
DIP SW1 - 3 rd
OFF
ON
CAM 2 CAM 3
DIP SW1 - 2 nd
OFF
OFF
ON
ON
22
THERMINATION
SW1-4th ON
CAM n
PROTOCOL
Pelco-D or Pelco-P
Not used
BAUD RATE
2,400bps
4,800bps
9,600bps
Not used