Motion Detection Setting - CBC Ganz ZT-WD Series Instruction Manual

OSD Menu
H. Motion Detection Setting
The motion detection detects the moving objects in the scene by monitoring changes in brightness level.
H-1. Select [MOTION DET] option.
H-2. Use [LEFT] or [RIGHT] button to select [ON] and press [SET]. The MOTION DETECTION menu appears.
H-3. Use [LEFT] or [RIGHT] button to select a Detect Sense from 0 to 127.
H-4. Use [LEFT] or [RIGHT] button to set up the [ON] or [OFF] on the block display.
H-5. Use [LEFT] or [RIGHT] button to set up the [ON] or [OFF] on the monitor area.
H-6. Use [UP] or [DOWN] to select an area select option from 1 to 4 then use [LEFT] or [RIGHT] button to
adjust the option
• TOP : Moves top position on the screen. (000 ~ 244)
• BOTTOM : Moves bottom position on the screen. (000 ~ 244)
• LEFT : Moves left position on the screen. (000 ~ 474)
• RIGHT : Moves right position on the screen. (000 ~ 474)
When the TOP and BOTTOM level is the same, the block would not be shown. And
Note!!
increase the top level, the bottom value would increase too, you could set it after fixing
the top level. While decrease the bottom level, the top level would decrease too. LEFT
and RIGHT relation is similar too.
MOTION DET
DETECT SENSE
BLOCK DISP OFF
MOTION AREA OFF
AREA SEL 1/4
TOP
BOTTOM
LEFT
RIGHT
RETURN ↵
17
110
020
100
060
190