Danby DAC150EB1GDB Owner's Use And Care Manual page 16

5
Install Support Bracket
1) Hold each support bracket flush against outside of sill, and tighten to bottom of cabinet as shown in Fig. J
brackets at top level of sill, and remove.
2) Assemble sill anchor bracket to outside support legs at the market positon, as seen in Fig. J
for any changes later. NOTE: Check that air conditioner is tilted downwards to the outside, about 3° to 4°, as shown in Fig. I.
After proper installation, condensed water should not drain from the overflow drain hole during normal use. If you notice
water leaking out , check the angle of tilt, and make any necessary adjustments. However, on a very humid day, water
leakage can occur – this is normal. Measure the tilt angle from the cabinet's edge. The distance H should be approximately
1 1/4" to 1 5/8".
3) Install support brackets (with sill anchor brackets attached) to correct hole in bottom of cabinet
as shown in Fig. K.
4) Tighten all 6 bolts securely.
Window Sash
Measure
the tilt
About 1¼ " to 1⅝"
angle from
the cabinet's
edge.
Side Louvers
Sill Angle Bracket
Window Sill
Fig. I
6
Extend Window Filler Panels
1) Extend panels to fill window opening completely. Secure the shutter clamp on each side of the (upper) shutter and
secure to window sill using one 7/16in.(12mm) locking screw & flat washer on each side. (Fig.L)
2) Attach frame lock to window sill using one 13/16in. (20mm) screw on each side as shown in Fig. L.
3) Close window behind "L" bracket as seen in Fig. L.
7
Install Window Lock and Sash Seal
1) Trim sash seal to fit window width. Insert into space between upper and lower sashes (Fig. M).
2) Attach right angle safety lock as shown in Fig. M.
8
Install Chassis into Cabinet and Install Front to Unit
1) Lift chassis and carefully slide into cabinet, leaving 6 inches protruding.
2) DO NOT push on controls or coils.
3) Be sure the chassis is firmly seated towards rear of cabinet.
4) Installation of front is the reverse of removal, outlined in section 1("Remove Chassis").
Fig.L
13/16in.(20mm) Screw & Frame Lock (2)
INSTALLATION INSTRUCTIONS
H
Mark
Fig. J
1
7/16in.(12mm)
locking screw &
h
flat washer.
1/2in.(12.7mm) Long
Left
Left Screws And
Locknuts
Locknut
Sill Anchor
Bracket
Flat Head
Bolt
2 Each Required For
Each Support Bracket
Fig. J
2
Fig.M
1/2" screw
14
. Mark
1
. Hand tighten, but allow
2
Right
Fig. K
Safety Lock
Window
Sash Seal